These are press-fit 3D printed brackets designed to replace the original cheap push buttons of video game lightguns with arcade quality microswitches behind the trigger. With these kits, you will get a very precise and responsive action on the trigger- accurate shots and no missed pulls, plus easier repeat fire. Installation is relatively simple, but you'll need a little soldering know-how, a willingness to use a screwdriver and a wire stripper. All kits are completely reversible and require no permanent alteration to your lightgun!
Please note that no lightguns are included!
You can review each install guide with sequential steps and pictures here:
Lightgun Trigger Kit Installation Guides
You may need to secure brackets with a dot of hot glue but they are designed to seat snugly. Relevant screws, a brand new microswitch (50 gram actuation force) and wire are included with each kit. As this is a DIY alteration, it is the buyer's responsibility to know what they're doing! Note that there could be some dimensional variance in the injection molded parts of your lightgun that the 3D printed parts fit into. You may have to perform some filing or use a razor/sharp knife to widen holes of the 3D printed parts if things are too tight. These kits are designed to be snug as it's better to have excess material instead of 'not enough.'
Any questions or troubleshooting requests are welcome! Just reach out via the contact page.
Contact / Customer Support
